• Send to a friend

    Send to a friend

    FrSky TFR8-S

    FrSky TFR8-S

    FrSky 8-channel receiver compatible with Futaba FASST.

    Recipient :

    * Required fields

      or  Cancel

  • PDF Product Page

  • FrSky TFR8-S


    New product

    FrSky 8-channel receiver compatible with Futaba FASST.

    More details

    This product is no longer in stock

    Price without tax 934 Kč

    Price with tax934 Kč

    In stock FW 2015


    • Two ways to set up failsafe - transceiver
    • updatable firmware
    • parallel connection of two RXs allows up to 14 channels


    • 8 channels
    • working voltage: 3.5-10 V
    • dimensions: 54mm × 30mm × 15mm
    • Weight: 12.9g
    • Adjustable frame: 14 ms (FS - Normal) and 7 ms (HS - High)
    • Compatibility: FASST 2.4G Air Systems (7CH Mode / Multi Mode): 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10 , TM-14, T14MZ, etc. FASST 2.4G Terrestrial System (C1 Mode): 3PK, 4PK, etc.


    To pair, hold the F / S button and connect the power to the receiver. When the red LED goes out and the green LED is on, pairing is completed.


    The receiver supports two kinds of filesafe:

    • Broadcast

    If the filesafe in the transmitter is not turned off, the receiver will use its settings.

    • Custom Failsafe Settings on All Channels

    Pair the receiver and turn off the filesafe in the transmitter. Set the channels to the desired positions, briefly press the F / S button, and the green LED will blink twice to indicate that filesafe values ​​are stored in the receiver.

    To cancel custom fileafe settings, you need to pair the receiver again.

    Unless you set filesafe otherwise, it will keep the last channel values ​​it had before it lost its signal.


    Red LED Green LED Meaning
    off is lit normal mode
    is lit is lit is waiting for pairing
    flashes is lit signal loss
    will blinks twice save filesafe
    flashes slowly is lit 14ms (FS - Normal)
    flashes fast is lit 7ms (HS - High)

    Change PPM mode

    Turn off the transmitter and receiver. Turn on the receiver only. Press the F / S button for 6 seconds and then release it. The LED will flash the selected mode. Repeat the above procedure for further change.

    HS mode is intended for use with fast servos only. Failure to do so may result in damage to the servo.

    Parallel connection of receivers

    TFR8-S can work with a second TFR8 / TFR8-S. This gives you 14 channels and each receiver can be placed in a different part of the model.

    Pair both receivers to the transmitter. Connect channel 1 and 2 with a jumper to switch channel 3 to 9, 4 to 10, etc.

    On all items we offer warranry 24 months.
    Spare parts and battries capacity 6 months.


    We provide warranty and post warranty services.

    Original manual in PDF

    Product In Same Categories